Symptom diagnosis

COMBINATION SWITCH SYSTEM SYMPTOMS Symptom Table 1. Perform “Data Monitor” of CONSULT-III to check for any malfunctioning item. 2. Check the malfunction combinations. 3. Identify the malfuncti ...

BCM (body control module)

Removal and Installation CAUTION: Before replacing BCM, perform “READ CONFIGURATION” to save or print current vehicle specification. Refer to BCS-150, "Description". REMOVAL (RHD MOD ...

Other materials:

Door lock status indicator does not illuminate
Diagnosis Procedure 1.CHECK DOOR LOCK STATUS INDICATOR Check door lock status indicator. Refer to DLK-395, "Component Function Check". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning parts. 2.CONFIRM THE OPERATION Conf ...

Hood switch
Component Function Check 1.CHECK FUNCTION 1. Select “HOOD SW” in “Data Monitor” mode of “IPDM E/R” using CONSULT-III. 2. Check “HOOD SW” indication under the following condition. Is the indication normal? YES >> Hood switch is OK. NO >> Go to SEC-155, "Diagnosis Procedure& ...

C1115 wheel sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...