Nissan Juke Service and Repair Manual : Removal and installation

Oil filter
Exploded View 1. O-ring 2. Oil filter bracket 3. Oil pressure switch 4. Oil filter 5. O-ring 6. Connecting bolt A. To oil cooler : N·m (kg-m, ft-lb) : Always replace after every disas ...

Oil pump
Exploded View 1. Oil pump drive chain 2. Crankshaft sprocket 3. Oil pump assembly Removal and Installation REMOVAL 1. Disconnect the battery cable from the negative terminal. 2. Remove eng ...

Other materials:

P159A, P159C, P159D G sensor
For M/T models : DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. T ...

P range interlock door lock/unlock function does not operate
Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode. 3. Check “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”. Refer to DLK-217, "DOOR LOCK ...

Power supply and ground circuit
Diagnosis Procedure 1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) IGNITION POWER SUPPLY 1. Turn the ignition switch OFF. 2. Disconnect ABS actuator and electric unit (control unit) harness connector. 3. Check voltage between ABS actuator and electric unit (control unit) harness conne ...