Service data and specifications (SDS)

Standard and Limit OIL PRESSURE OIL CAPACITY (APPROXIMATE) TIGHTENING TORQUE ...

Precaution

...

Other materials:

P0710 transmission fluid temperature sensor A
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, p ...

Preparation
Special Service Tools BASIC INSPECTION STEERING WHEEL Inspection NEUTRAL POSITION STEERING WHEEL 1. Make sure that steering gear assembly, steering column assembly and steering wheel are installed in the correct position. 2. Perform neutral position inspection after wheel alignment. Refer ...

Calibration of decel G sensor
Description TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed. • Removal/installation or replacement of G sensor • Replacement of TCM Proce ...