Wiring diagram

MANUAL HEATER SYSTEM Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connec ...

Diagnosis and repair workflow

Work Flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW FOR MALFUNCTION Interview the symptom to the customer. >> GO TO 2. 2.SYMPTOM CHECK Check the symptom from the customer's informa ...

Other materials:

Intelligent key battery
Removal and Installation 1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key. 2. Insert a flat-blade screwdriver (A) wrapped with a cloth into the slit of the corner and twist it to separate the upper part from the lower part. CAUTION: • Do not touch t ...

Stall test
Work Procedure INSPECTION 1. Check the engine oil level. Replenish if necessary. Refer to LU-25, "Inspection". 2. Check for leak of the CVT fluid. Refer to TM-480, "Inspection". 3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 t ...

Diagnosis system (BCM)
Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the ...