Nissan Juke Service and Repair Manual : P1701 TCM

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

1. Start the engine and wait for 5 seconds or more.

2. Check the first trip DTC.

Is “P1701” detected? YES >> Go to TM-440, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK TCM POWER SUPPLY (BACK-UP) CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect the TCM connector.

3. Check the voltage between the TCM harness connector terminals and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 2.

2.DETECTION OF MALFUNCTION ITEMS

Check the following items: • Open or short circuit of the harness between battery positive terminal and TCM connectors terminals 45 and 46. Refer to PG-10, "Wiring Diagram - BATTERY POWER SUPPLY -".

• 10A fuse (No.33, fuse and fusible link block). Refer to PG-23, "Fuse and Fusible Link Arrangement".

• 10A fuse (No.36, fuse and fusible link block). Refer to PG-23, "Fuse and Fusible Link Arrangement".

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> Repair or replace the malfunctioning parts.

    P1588 G sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just befor ...

    P1739 1GR incorrect ratio
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: • Be sure to perform “TM-442, "Diagnosis Procedure"” and then perform “DTC CONFIRMATION PROCEDURE”. • Never perform ...

    Other materials:

    Vehicle Recovery (Freeing a Stuck Vehicle)
    FRONT 1. Remove the hook cover from the bumper using a remover tool. 2. Securely install the vehicle recovery hook stored with jacking tools. Check that the hook is properly secured in the stored place after use. WARNING: • Stand clear of a stuck vehicle. • Never spin your tires at high spe ...

    System (intelligent key system)
    Intelligent key system : System Diagram Intelligent key system : System Description • The Intelligent Key system is a system that makes it possible to lock and unlock the door locks (door lock/ unlock function) by carrying the Intelligent Key, which operates based on the results of electron ...

    Fender protector
    Exploded View 1. Hoodledge insurator 2. Fender protector 3. U nut 4. Air guide 5. Screw grommet A. To hoodledge panel : Vehicle front Removal and Installation REMOVAL 1. Remove front fillet molding. Refer to EXT-26, "FRONT FILLET MOLDING : Removal and Installation". 2. Re ...