Nissan Juke Service and Repair Manual : P0846 transmission fluid pressure SEN/SW B

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

CAUTION:
Be careful of the driving speed.

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

1. Start the engine.

2. Shift the selector lever to “D” position.

3. Drive the vehicle at a constant velocity of 40 km/h (25 MPH) at lease for 10 seconds.

CAUTION:
At the same time, the accelerator pedal angle must be maintained constant.

4. Stop the vehicle.

5. Check the first trip DTC.

Is “P0846”detected? YES >> Go to TM-425, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK TCM INPUT SIGNAL

1. Start the engine.

2. Check the voltage between TCM connector terminal and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> There is a malfunction of the secondary pressure sensor value. Replace the transaxle assembly.

Refer to TM-508, "Removal and Installation".

    P0746 pressure control solenoid A
    DTC Logic DTC DETECTION LOGIC NOTE: DC stands for "DRIVING CYCLE" and indicates a series of driving cycle of "Ignition switch OFF → ON → driving → OFF". ...

    P0847 transmission fluid pressure SEN/SW B
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for a ...

    Other materials:

    Intake manifold
    Exploded View 1. EVAP canister purge volume control solenoid valve 2. Hose clamp 3. Vacuum hose 4. Intake manifold support 5. Gasket 6. Intake manifold 7. Electric throttle control actuator 8. Gasket A. To air cleaner B. To centralized under-floor piping C. To brake booster D. ...

    Thermo control amplifier
    Component Function Check 1.CHECK A/C ON SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 3. Select “THERMO AMP” in “DATA MONITOR” mode, and check status under the following condition. Is the inspection result normal? YES >> ...

    Cowl top
    Exploded View LHD models 1. Front fender cover RH 2. Cowl top cover seal 3. Blind plug RH 4. Cowl top cover 5. Cowl top cover cap 6. Cowl top extension 7. EPT seal [t: 3.0 mm (0.118 in)] 8. Air intake cover 9. Blind plug LH 10. Front fender cover LH 11. Washer nozzle : Clip : ...