Nissan Juke Service and Repair Manual : System description

Sealant or/and Lubricant
HFC-134a (R-134a) Service Tool and Equipment • Never mix HFC-134a (R-134a) refrigerant and/or its specified lubricant with CFC-12 (R-12) refrigerant and/ or its lubricant. • Separate and non-inte ...

Component parts
Component Parts Location 1. Expansion valve 2. Condenser 3. Compressor 4. Refrigerant pressure sensor 5. Liquid tank 6. Evaporator A. Built-in heater & cooling unit assembly Componen ...

Other materials:

Drive pinion
Exploded View 1. Filler plug 2. Gasket 3. Drain plug 4. Breather tube 5. Clip 6. Breather hose 7. Breather 8. sub-harness clip 9. sub-harness 10. Rear cover 11. Center stem 12. Side bearing (right) 13. Side bearing adjusting shim (right) 14. Side oil seal (right) 15. Conne ...

Intelligent key
Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “RKE OPE COUN1” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Intelligent ...

P0826 up and down shift SW
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. After the repair, p ...