Steering switch ground circuit

Description Transmits the steering switch signal to NAVI control unit. Diagnosis Procedure 1.CHECK STEERING SWITCH SIGNAL GROUND CIRCUIT 1. Disconnect NAVI control unit connector and spiral cable ...

Navigation system

Symptom Table RELATED TO NAVIGATION NOTE: Combined part of AV switch and NAVI control unit. RELATED TO HANDS-FREE PHONE • Check that the cellular phone is the corresponding type (Bluetooth™ e ...

Other materials:

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

P0745 pressure control solenoid A
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, perform the following procedure to confirm the mal ...

Cooling fan
Exploded View 1. Fan motor 2. Fan shroud 3. Cooling fan A. Apply on fan motor shaft : N·m (kg-m, in-lb) : Apply genuine high strength thread locking sealant or equivalent. Removal and Installation REMOVAL 1. Drain engine coolant. Refer to CO-11, "Draining". CAUTION: • Pe ...