Nissan Juke Service and Repair Manual : Symptom diagnosis
- Door does not lock/unlock with door lock and unlock switch
- Door does not lock/unlock with driver side door lock knob or door key cylinder
- Door does not lock/unlock with keyfob
- Back door does not opened
- ANTI-HIJACK function does not operate
- Vehicle speed sensing auto lock operation does not operate
- IGN off interlock door unlock function does not operate
- P range interlock door lock/unlock function does not operate
- Auto door lock operation does not operate
- Unlock link function does not operate
- Key out interlock door unlock function does not operate
- Key reminder function does not operate
- Hazard reminder operation does not operate
- Squeak and rattle trouble diagnoses
Unlock sensor
Component Function Check
1.CHECK FUNCTION
1. Select “DOOR LOCK” of “BCM” using CONSULT-III.
2. Select “LOCK STATUS” in “DATA MONITOR” mode.
3. Check that the function operates normally according t ...
Door does not lock/unlock with door lock and unlock
switch
All door
ALL DOOR : Description
All doors do not lock/unlock using door lock and unlock switch.
ALL DOOR : Diagnosis Procedure
1.CHECK DOOR LOCK AND UNLOCK SWITCH
Check door lock and unlock switc ...
Other materials:
Fuel gauge
The gauge1 indicates the approximate fuel level in the tank.
The gauge may move slightly during braking, turning, acceleration, or going up
or down hills.
Refill the fuel tank before the gauge registers 0 (empty). The low fuel
warning light illuminates when the
amount of fuel in the tank ...
How to select piston and bearing
Description
• The identification grade stamped on each part is the grade for the
dimension measured in new condition. This grade cannot apply to reused parts.
• For reused or repaired parts, measure the dimension accurately. Determine the
grade by comparing the
measurement with the values o ...
B1178 lap Pre-tensioner RH
DTC Logic
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to SRC ...