PTC heater

Component Function Check 1.CHECK PTC HEATER OPERATION 1. Start the engine. 2. Operate fan control dial. 3. Operate temperature control dial to full hot position. 4. Check for warm air at discharg ...

Automatic air conditioner system

Symptom Table NOTE: Perform self-diagnoses with CONSULT-III before performing the symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis. *: With K9K engine models ...

Other materials:

Back door opener system
System Diagram System Description BACK DOOR OPENER OPERATION When back door opener switch is pressed, BCM operates back door opener actuator. NOTE: Back door opener actuator is not for locking the back door. The function is only to open the back door. OPERATION CONDITION If the foll ...

Inside key antenna
Instrument center INSTRUMENT CENTER : Removal and Installation REMOVAL 1. Remove the multi display unit. Refer to AV-125, "Removal and Installation". 2. Remove the inside key antenna (instrument center) (1) mounting clip (A), and then remove inside key antenna (instrument center). ...

General Precautions
• Always use a 12 volt battery as power source. • Do not attempt to disconnect battery cables while engine is running. • Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF, wait 3 minutes and disconnect battery negative cable. Failure to do so may damage the ...