Precaution

REPAIRING HIGH STRENGTH STEEL High Strength Steel (HSS) High strength steel is used for body panels in order to reduce vehicle weight. Accordingly, precautions in repairing automotive bodies ma ...

Repairing material

Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foa ...

Other materials:

P0826 up and down shift SW
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. After the repair, p ...

Line pressure test
Work Procedure INSPECTION 1. Check the engine oil level. Replenish if necessary. LU-25, "Inspection". 2. Check for leak of the CVT fluid. Refer to TM-480, "Inspection". 3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (122 ...

B27A2, B27A3, B27A4, B27A5 air mix door motor
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 51, "DTC Logic". • If DTC is displayed along with DTC U1010, first perform the trouble diagnosis for DTC U1010. HAC-52, "DTC Logic ...