Precaution Necessary for Steering Wheel Rotation after Battery Disconnect

NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all contro ...

System description

VENTILATION SYSTEM System Description OUTLINE Ventilation system is controlled by A/C auto amp. (AUTOMATIC AIR CONDITIONING) or A/C control (MANUAL AIR CONDITIONING and MANUAL HEATER). For detai ...

Other materials:

Front fog lamp aiming adjustment
Description PREPARATION BEFORE ADJUSTING NOTE: For details, refer to the regulations in your own country. Before performing aiming adjustment, check the following. • Adjust the tire pressure to the specification. • Fill with fuel, engine coolant and each oil. • Maintain the unloaded vehic ...

C1144 incomplete steering angle sensor adjustment
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...

P0137 HO2S2
DTC Logic DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst 1 causes the longer switching time. To judge the malfunctions of heated oxygen sensor 2, ...