Nissan Juke Service and Repair Manual : Periodical Maintenance Specification

ENGINE OIL CAPACITY (APPROXIMATE)

Engine Oil Pressure


    Engine Oil Pressure
    *: Engine oil temperature at 80°C (176°F) ...

    Other materials:

    P0833 CPP switch
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK CLUTCH PEDAL POSITION SWITCH GROUND CIRCUIT FOR OPEN AND SHORT 1. Turn ignition switch OFF. 2. Disconnect clutch pedal position switch harness connector. 3. Check the continuity between clutch pedal position switch harness connector ...

    NISSAN Vehicle Immobilizer System
    The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of the registered key. If the engine fails to start using the registered key, it may be due to interference caused by another registered key, an automated toll road device or automated payment device on t ...

    P1778 step motor
    Description • The step motor's 4 aspects of ON/OFF change according to the signal from TCM. As a result, the flow of line pressure to primary pulley is changed and pulley ratio is controlled. • This diagnosis item is detected when electrical system is OK, but mechanical system is NG. • This ...