Nissan Juke Owners Manual : Exterior and interior lights
: See a NISSAN dealer for replacement.
NOTE: Always check with the Parts Department at a NISSAN dealer for the latest information about parts.
: REMOVE
: INSTALL
Replacement procedures
All other lights are either type A, B, C, D or E.
When replacing a bulb, first remove the lens and/or cover.
Map light
Cargo light
Headlights
Fog may temporarily form inside the lens of the exterior lights in the rain or
in a car wash. A temperature difference between the inside and the outside of the
lens causes the fog. This is not a ...
Wheels and tires
If you have a flat tire, see “Flat tire” . ...
Other materials:
C1601 battery power supply
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With ...
Multiport Fuel Injection System or Engine Control System
• Before connecting or disconnecting any harness connector for the
multiport fuel injection system or ECM:
Turn ignition switch to “OFF” position.
Disconnect negative battery terminal. Otherwise, there may be damage to ECM.
• Before disconnecting pressurized fuel line from fuel pump to injecto ...
P1556, P1557 battery temperature
sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
1. Turn ignition switch OFF and wait at lest 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm ...
