Nissan Juke Service and Repair Manual : CVT shift lock system

Wiring diagram

For connector terminal arrangements, harness layouts, and alphabets in a notdescribed(option abbreviation; if
notdescribed in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation".

Basic inspection


    CVT control system
    Wiring diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if notdescribed in wiring diagram), refer to GI-12, "Connector Information/Expl ...

    Other materials:

    P181B incomplete selfshut
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

    P0840 transmission fluid pressure SEN/SW A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, perform the following procedure to confirm the mal ...

    Too much power
    Description CHART 13: TOO MUCH POWER Diagnosis Procedure 1.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT Check ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Procedure". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace harness ...