Nissan Juke Service and Repair Manual : Audio unit
Removal and Installation
REMOVAL
1. Remove cluster lid C. Refer to IP-12, "Exploded View".
2. Remove audio unit screws.
3. Disconnect audio unit connectors to remove audio unit and brackets as a single unit.
4. Remove brackets screws to remove audio unit.
INSTALLATION
1. Install in the reverse order of removal.
2. Enter the anti-theft code (with USB connection function models). Refer to AV-23, "Work Procedure".
Front door speaker
Removal
and Installation
REMOVAL
1. Remove front door finisher. Refer to INT-13, "Exploded View".
2. Remove front door speaker screws, then disconnect front door speaker
connector and ...
Other materials:
Removal and installation
PUSH-BUTTON IGNITION SWITCH
Removal and Installation
REMOVAL
1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and
Installation".
2. Remove the push-button ignition switch.
1. Disengage the push-button ignition switch fixing pawls
using minus driver etc.
2. Press the pu ...
Vehicle Dynamic Control (VDC) off switch
The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on
for most driving conditions.
If the vehicle is stuck in mud or snow, the VDC system reduces the engine output
to reduce wheel spin. The engine speed will be reduced even if the accelerator is
depressed to the floo ...
Remote keyless entry receiver
Component Function Check
1.CHECK FUNCTION
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “RKE OPE COUN1” in “DATA MONITOR” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Remote keyle ...