Nissan Juke Service and Repair Manual : Service data and specifications

Inspection
INSPECTION AFTER REMOVAL Appearance Check the propeller shaft for bend and damage. If damage is detected, replace propeller shaft assembly. Propeller Shaft Runout Check propeller shaft runout ...

Other materials:

Oil pressure switch signal circuit
Component Function Check 1.CHECK COMBINATION METER INPUT SIGNAL Select the “Data Monitor” for the “METER/M&A” and check the “OIL W/L” monitor value. “OIL W/L” Ignition switch ON : On Engine running : Off >> INSPECTION END Diagnosis Procedure 1.CHECK OIL PRESSURE SWITCH CIRCUIT 1 ...

Hood switch
Component Function Check 1.CHECK FUNCTION 1. Select “HOOD SW” in “Data Monitor” mode of “IPDM E/R” using CONSULT-III. 2. Check “HOOD SW” indication under the following condition. Is the indication normal? YES >> Hood switch is OK. NO >> Go to SEC-223, "Diagnosis Procedure& ...

B2601 shift position
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2601 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B2601 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "D ...