Nissan Juke Service and Repair Manual : Refrigerant pressure sensor

Exploded View

Refer to HA-94, "Exploded View".

Removal and Installation

REMOVAL

Refer to HA-96, "REFRIGERANT PRESSURE SENSOR : Removal and Installation".

INSTALLATION

Install in the reverse order of removal.

    Intake sensor
    Exploded View Refer to HA-97, "Exploded View (Automatic Air Conditioning)". Removal and Installation REMOVAL 1. Remove evaporator assembly. Refer to HA-115, "EVAPORATOR : Removal an ...

    Power transistor
    Exploded View 1. A/C unit assembly 2. Blower fan resistor*1 3. Sub harness*1 4. Power transistor*2 5. Sub harness*2 6. Blower motor • *1: Manual air conditioner • *2: Automatic air condi ...

    Other materials:

    Wiring diagram
    Engine control system Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

    Service
    • Never use electrical test equipment to check SRS circuits unless instructed to in this Service Manual. • Before servicing the SRS, turn ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes. For approximately 3 minutes after the battery negative terminal ar ...

    P0130 A/F sensor 1
    DTC Logic DTC DETECTION LOGIC To judge malfunctions, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal fluctuates according to fuel feedback control. DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted ...