Nissan Juke Service and Repair Manual : Precaution for Procedure without Cowl Top Cover

When performing the procedure after removing cowl top cover, cover the lower end of windshield with urethane, etc.

On Board Diagnostic (OBD) System of Engine and CVT


    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
    The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passen ...

    On Board Diagnostic (OBD) System of Engine and CVT
    The ECM has an on board diagnostic system. It will light up the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration. CAUTION: • Be sure to turn t ...

    Other materials:

    Drive belt idler pulley
    Removal and Installation REMOVAL 1. Remove drive belt. Refer to EM-155, "Removal and Installation". 2. Remove the lock nut, and then remove the plate (7), idler pulley (6), and washer (5). 1 : Alternator bracket 3. Remove the center shaft (2) together with the spacer (3) with insert ...

    P0744 torque converter
    Description This malfunction is detected when the torque converter clutch does not lock-up as instructed by the TCM. This is not only caused by electrical malfunction (circuits open or shorted), but also by mechanical malfunction such as control valve sticking, improper solenoid valve operati ...

    High pressure fuel pump
    Component Function Check 1.CHECK HIGH PRESSURE FUEL PUMP FUNCTION With CONSULT-III 1. Start engine. 2. Check “FUEL PRES SEN V” in “DATA MONITOR” mode of “ENGINE” using CONSULT-III. Without CONSULT-III 1. Start engine. 2. Check the voltage between ECM harness connector terminals as per the ...