Nissan Juke Service and Repair Manual : How to use this section

Caution

• This section describes information peculiar to a vehicle and inspection procedures.

• For trouble diagnosis procedure, refer to LAN-17, "Trouble Diagnosis Procedure".

Abbreviation List

Unit name abbreviations in CONSULT-III CAN diagnosis and in this section are as per the following list.

Precaution


    Other materials:

    P1832 TCS operation signal
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DTC REPRODUCTION PROCEDURE With CONSULT-III 1. Start the engine and drive at 30 km/h (19 MPH) or more. 2. Perform self-diagnosis for “ALL MODE AWD/4WD”. Is DTC “P1832” detected? YES >> Proceed to diagnosis procedure. Refer ...

    P0075 IVT control solenoid valve
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO2. 2.PERFORM DTC CONFIRMATION PROCEDURE ...

    Draining
    1. Run the vehicle to warm up the transfer unit sufficiently. 2. Stop the engine and remove the drain plug (1) and gascket to drain the transfer oil. 3. Before installing drain plug, set a new gasket. Install drain plug on the transfer and tighten to the specified torque. Refer to DLN- 113, &qu ...