General information

...

Description

This volume explains “Removal, Disassembly, Installation, Inspection and Adjustment” and “Trouble Diagnoses”. ...

Other materials:

P0745 pressure control solenoid A
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, perform the following procedure to confirm the mal ...

Removal and Installation
REMOVAL • Disconnect each joint and mounting. • Remove heated oxygen sensor 2 with following procedure: - Using heated oxygen sensor wrench [SST: KV10114400] (A), removal heated oxygen sensor 2 (1). CAUTION: Be careful not to damage heated oxygen sensor 2. INSTALLATION Note the following ...

Turbocharger boost control
Turbocharger boost control : SystemDiagram Turbocharger boost control : System Description INPUT/OUTPUT SIGNAL CHART SYSTEM DESCRIPTION Depending on driving conditions, the ECM performs ON/OFF duty control of the turbocharger boost control solenoid valve and controls the boost by adjustin ...