Nissan Juke Service and Repair Manual : Connecting Rod Bearing


Engine Mechanical K9K


    Other materials:

    Headlamp washer relay
    Component Inspection 1.CHECK HEADLAMP WASHER RELAY 1. Turn the ignition switch OFF. 2. Remove headlamp washer relay. 3. Apply battery voltage to headlamp washer relay between terminals 1 and 2. 4. Check continuity of headlamp washer relay. Is the inspection result normal? YES >> Headl ...

    P0117, P0118 ECT SENSOR
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE ...

    Precaution
    Precautions for Drive Shaft • Observe the following precautions when disassembling and assembling drive shaft. - Never disassemble joint sub-assembly because it is non-overhaul parts. - Perform work in a location which is as dust-free as possible. - Clean the parts, before disassembling and ...