Special Service Tools

System description

Other materials:

Adjustment of steering angle sensor neutral position
Description Always adjust the neutral position of steering angle sensor before driving when the following operation is performed. Work Procedure ADJUST THE NEUTRAL POSITION OF STEERING ANGLE SENSOR CAUTION: Always use CONSULT-III when adjusting the neutral position of steering angle senso ...

C1105, C1106, C1107, C1108 wheel sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT-I ...

Locking with power door lock switch
Driver’s armrest Operating the power door lock switch will lock or unlock all the doors. The switch is located on the driver’s door armrest. To lock the doors, push the power door lock switch to the lock position 1 with the driver’s door open, then close the door. When locking the door this ...