Nissan Juke Service and Repair Manual : Clutch Disc

Clutch Cover


    Clutch Pedal
    *1 : With push-button ignition switch system *2 : With ASCD or with push-button ignition switch system ...

    Other materials:

    C1115 wheel sensor
    DTC Logic DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT-III. 1. Stat the en ...

    Removal and installation
    PUSH-BUTTON IGNITION SWITCH Removal and Installation REMOVAL 1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and Installation". 2. Remove the push-button ignition switch. 1. Disengage the push-button ignition switch fixing pawls using minus driver etc. 2. Press the pu ...

    Line pressure test
    Work Procedure INSPECTION 1. Check the engine oil level. Replenish if necessary. LU-25, "Inspection". 2. Check for leak of the CVT fluid. Refer to TM-480, "Inspection". 3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (122 ...