Nissan Juke Service and Repair Manual : Board-On Lift

CAUTION:
Check vehicle is empty when lifting.

• The board-on lift attachment (A) set at front end of vehicle should be set on the front of the sill under the front door opening.

• Position attachments at front and rear ends of board-on lift.

: Vehicle front


Tow truck towing


    Garage Jack and Safety Stand and 2-Pole Lift
    WARNING: • Park the vehicle on a level surface when using the jack. Check to avoid damaging pipes, tubes, etc. under the vehicle. • Never get under the vehicle while it is supported only by the ...

    Other materials:

    On board diagnostic (OBD) system
    Description This is an onboard diagnosis system which records diagnosis information related to the exhaust gases. It detects malfunctions related to sensors and actuators. The malfunctions are indicated by means of the malfunction indicator lamp (MIL) and are stored as DTC in the ECU memory. ...

    General Precautions
    • Turn ignition switch OFF and disconnect the battery cable from the negative terminal before connecting or disconnecting the CVT assembly harness connector. Because battery voltage is applied to TCM even if ignition switch is turned OFF. • When connecting or disconnecting pin connectors into ...

    System
    4WD system : System Diagram INPUT/OUTPUT SIGNAL It transmits/receives each signal from the following 4WD control module via CAN communication line. 4WD system : System Description • 4WD mode is selectable among 2WD, 4WD-V, and 4WD by operating the 4WD mode switch. • When judging drivi ...