Nissan Juke Owners Manual : Air conditioner specification label

The air conditioner specification label is attached to the engine compartment


The air conditioner specification label is attached to the engine compartment as shown.

    Tire and Loading Information label
    The cold tire pressure is shown on the Tire and Loading Information label affixed to the pillar as shown. ...

    Installing front license plate
    Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag. •  License plate bracket •  J- ...

    Other materials:

    B1080, B1096 driver air bag module
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

    P1811 power supply circuit for 4wd control module
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

    Engine stand setting
    NOTE: Explained here is how to disassemble with engine stand supporting transaxle surface. When using different type of engine stand, note with difference in steps and etc. 1. Remove the engine and the transaxle assembly from the vehicle, and separate the transaxle from the engine. Refer t ...