Nissan Juke Service and Repair Manual : Removal and installation
Compressor dose dot operate
Description SYMPTOM Compressor dose not operate. Diagnosis Procedure NOTE: • Perform self-diagnosis with CONSULT-III before performing symptom diagnosis. If any malfunction result or DTC is de ...A/C control
Exploded View 1. Intake door cable 2. Air mix door cable 3. Mode door cable 4. A/C control 5. Intake door lever knob A. To intake door link B. To air mix door link C. To mode door link ...Other materials:
Liquid Gasket
REMOVAL OF LIQUID GASKET SEALING
• After removing mounting nuts and bolts, separate the mating surface
using the seal cutter [SST: KV10111100 (J-37228)] (A) and
remove old liquid gasket sealing.
CAUTION:
Be careful not to damage the mating surfaces.
• Tap the seal cutter [SST: KV10111100 (J- ...
Unlock link function does not operate
Diagnosis Procedure
1.CHECK DRIVER SIDE OR PASSENGER SIDE DOOR SWITCH
Check driver side or passenger side door switch.
Refer to DLK-258, "Component Function Check".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
...
B1118, B1119 satellite sensor LH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...