Nissan Juke Service and Repair Manual : Commercial Service Tools


System description


    Other materials:

    B1011, B1012, B1013, B1014, B1015 diagnosis sensor unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

    P0501, P2159 vehicle speed sensor
    Description ECM receives a rear wheel sensor signal from ABS actuator and electric unit (control unit) via CAN communication to switch combustion for the direct injection gasoline system. For the direct injection gasoline system, refer toEC-48, "DIRECT INJECTION GASOLINE SYSTEM : System ...

    Draining
    1. Start engine and let it run to warm up transaxle. 2. Stop engine. Remove drain plug (1) and gasket, using a socket [Commercial service tool] and then drain gear oil. 3. Set a gasket on drain plug and install it to clutch housing, using a socket [Commercial service tool]. CAUTION: Never re ...