Vehicle Recovery (Freeing a Stuck Vehicle)

FRONT 1. Remove the hook cover from the bumper using a remover tool. 2. Securely install the vehicle recovery hook stored with jacking tools. Check that the hook is properly secured in the store ...

Service information for electrical incident

Work Flow WORK FLOW Control Units and Electrical Parts PRECAUTIONS • Never reverse polarity of battery terminals. • Install only parts specified for a vehicle. • Before replacing the control ...

Other materials:

Doors
WARNING •  Always have the doors locked while driving. Along with the use of seat belts, this provides greater safety in the event of an accident by helping to prevent persons from being thrown from the vehicle. This also helps keep children and others from unintentionally opening the do ...

P0037, P0038 HO2S2 heater
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

The fuel gauge indicator does not operate
Description Fuel gauge will not indicate from a certain position. Diagnosis Procedure 1.CHECK COMBINATION METER OUTPUT SIGNAL 1. Connect CONSULT-III. 2. Select the “Data Monitor” for the “METER/M&A” and compare the “FUEL METER” monitor value with the fuel gauge reading on the combination ...